superdude201 Posted August 9, 2002 Share Posted August 9, 2002 A brush i am using is a block right and i want to know how u can curve the edges like at tigris's cantina for something i am making on my map. Thanks Link to comment Share on other sites More sharing options...
Drakewl Posted August 9, 2002 Share Posted August 9, 2002 its all with patches better to read the tutorials in the sticky threads Link to comment Share on other sites More sharing options...
superdude201 Posted August 9, 2002 Author Share Posted August 9, 2002 I can't find where it tells u how to make edges go into a curve in the sticky forums. Link to comment Share on other sites More sharing options...
Drakewl Posted August 9, 2002 Share Posted August 9, 2002 you must have small eyes if you dont have seen rich diesals university tutorial thread, hehe just joking you can find the tutorials here: http://richdiesal.jedioutcastmaps.com/tutorials/ don't wonder, patches = curves Link to comment Share on other sites More sharing options...
superdude201 Posted August 9, 2002 Author Share Posted August 9, 2002 I meant on the outside of the building. Is there one there for the outside or can u just do the same as on the inside? Link to comment Share on other sites More sharing options...
Drakewl Posted August 9, 2002 Share Posted August 9, 2002 its pretty the same, just depends on you if you use curves in- or outdoor if you want that the faces of your patch look to the other direction, just go to matrix in the patch menu in radiant and invert it, the rest is described within the tutorials which are pretty good to understand together with the vertex editing tool (press v while your patch is selected) you can edit your curve into your own shapes Link to comment Share on other sites More sharing options...
Joben Posted August 12, 2002 Share Posted August 12, 2002 HA i found this question again finaly. putting a curve on the outside is pretty simple. Stuff you need, two wall brushes, a 90 degree patch (bevel) Now you have your two big flat wall brushes right? ok this is a top down view. ll ll ll ll *======== Set them up like that. They should only touch at their corners. no flat faces of the walls should be in contact. The * represents your patch I know that is hard to follow but realy this is almost impossible to say in words... and ASCII charecter pictures dont help much...hope you get the idea. Link to comment Share on other sites More sharing options...
superdude201 Posted August 12, 2002 Author Share Posted August 12, 2002 Ok i'll try that Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.