superdude201 Posted August 20, 2002 Share Posted August 20, 2002 Is it possible to cut a door way in bevel curves? Cause on my moisterfarm i am putting that hole bit and they have rooms at the bottom and i planned to do that but is it possible? Link to comment Share on other sites More sharing options...
alanuk Posted August 20, 2002 Share Posted August 20, 2002 well when u thinken or caped you beval it says its a func_group when slecet bring up the entire list and at the top you will see group entires or ungroup enitres. this should take of the func_group oki now diselected make an other beval, make it door height and door textuer, thinken it, ungroup the enitre so there no func_group on it, and cut a hole in the wall with that beval size door. if you want to make a door just put func door on it, for angle i should say down beacuse it will just com out of the walls if went sideways alan Link to comment Share on other sites More sharing options...
volrathxp Posted August 20, 2002 Share Posted August 20, 2002 i usually just build around areas where i need to have a hole and use four capped bevels, works well. i just wish smaller bevels/endcaps/cylinders were possible. Link to comment Share on other sites More sharing options...
superdude201 Posted August 20, 2002 Author Share Posted August 20, 2002 Yeah so do i i was planning to have a c3p0 eye in the droid shop or the moister farm but when it gets so small it goes all squarey Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.