Kyle_KatarnJedi Posted July 1, 2003 Share Posted July 1, 2003 I went to compile my map and I got: Exceeded MAX_SURFACE_VERTS (MAX_SURFACE_VERTS = 256) I did brush clean up, I just dont know how to fix this? Anyideas? Link to comment Share on other sites More sharing options...
Leslie Judge Posted July 1, 2003 Share Posted July 1, 2003 Try to find a very big brush (or not so big ) which is touched by many other brushes and cut it into two halves or more if needed. Link to comment Share on other sites More sharing options...
Kyle_KatarnJedi Posted July 2, 2003 Author Share Posted July 2, 2003 Thanks a lot! It compiled fine now! Link to comment Share on other sites More sharing options...
Kyle_KatarnJedi Posted July 6, 2003 Author Share Posted July 6, 2003 Ok I got this, NumPoints (88) exceed MAX_POINTS_ON_WINDING (64). Sample points: (2152.00 2688.00 960.00) (2152.00 3168.00 960.00) (2152.00 3648.00 960.00) Is this the same as the MAX_VERTS are the (2152.00 3168.00 960.00) where hte brush is located? Link to comment Share on other sites More sharing options...
RoxStar Posted July 6, 2003 Share Posted July 6, 2003 Possibly just do what Leslie said again. Link to comment Share on other sites More sharing options...
Leslie Judge Posted July 6, 2003 Share Posted July 6, 2003 Yepp, do it again. And yes, the coords give you a sample, so look around that for the big brush. Link to comment Share on other sites More sharing options...
RoxStar Posted July 7, 2003 Share Posted July 7, 2003 Woohoo I was right! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.