MoNKeY-150 Posted September 29, 2003 Share Posted September 29, 2003 I have just started a new map, and it I have compiled it a few times when I wanted to test it, and that was fine. Now, for some reason when i walk or run on a few of my floors, it sounds like im walking on water (sloshing noise). "impdetention/floor2" is the texture, and when I press the hotkey "n" to check the entities atributes and such there is nothing that would indicate it was set to a water brush. so i dont know what to do, and i dont want my floors sounding like im walking through water. Please help me. Thanks ;-{) Link to comment Share on other sites More sharing options...
Lil Killa Posted September 29, 2003 Share Posted September 29, 2003 the texture has a shader applied to it so that it sounds like your walking on metal in SP but it does not work in MP for JK2. In JA however, the sounds work for both MP and SP Link to comment Share on other sites More sharing options...
lukeskywalker1 Posted September 29, 2003 Share Posted September 29, 2003 If its a jk2 map, i have your solution. I was messing around a while back, and figured this out. The clip texture has normal foot sounds in jk2. So just make a super super thing clip textured floor, the same size as your floor. Put it down so that the floor and the clip floor "z-fight" (they are perfectly level... In game, you wont see the clip textured floor only your floor, but you will hear the clip textured sounds (the normal foot sounds) and if you do it right, it wont look like your floating above the ground a little bit. Link to comment Share on other sites More sharing options...
MoNKeY-150 Posted October 1, 2003 Author Share Posted October 1, 2003 OK I get it. Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.