Jedi Targus Posted July 21, 2009 Share Posted July 21, 2009 After exporting my models from NwMax i run them through MDLops, but sometimes it comes up with an error saying it couldn't read the MDX file. Does anyone know why or what i am doing wrong? Link to comment Share on other sites More sharing options...
ROTNR Posted July 21, 2009 Share Posted July 21, 2009 hmm... not sure if you have this fixed or not since I just replied to your other thread, but what you will want to do is #1. Make sure you are NOT re-reading or writing your -ascii file. #2. Make sure that you save your new .mdl file to another location to avoid confusion #3. Click Read and Write Again, not sure if you have this fixed or not, and I hope this helps you =), -Pete Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.