Tyler_Durden Posted October 8, 2002 Share Posted October 8, 2002 This may seem like the stupidest thing but I tried making a doorway from one room to another but for some reason the clip tool cuts either the top half or the bottom half of the area in which i want to make the door, I tried rich diesal's way of doing it but it doesn't seem to work the way it's supposed to can someone help me out with this problem? I've spent like 2 hours rying to figure it out. Link to comment Share on other sites More sharing options...
Leslie Judge Posted October 8, 2002 Share Posted October 8, 2002 OK, first select the wall. Press X and set the two clip points. Now press SHIFT+ENTER! Press ESC twice to deselect everything, and select that half of the wall, where you have to cut some more, and repeat the above steps. At the end you want to keep only one half of the brush, so you have to use ENTER WITHOUT SHIFT. If the program wants to keep the wrong half, then press CTRL+ENTER first and then ENTER. I hope this was helpful. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.