nizwiz Posted March 23, 2008 Share Posted March 23, 2008 In singleplayer, whenever one un/equips a weapon, a very short animation is played (as can be witnessed by enetering "weapon 0" / "weapon 1" / "weapon 0" on the console). Does anyone know where these sequences are to be found in animations.cfg? (I'm not talking of the BOTH_STAND1TO2 and BOTH_STAND2TO1 sequences; if you're equipping your saber from "weapon 0" mode, a few additional frames can be seen before the BOTH_STAND1TO2 sequence starts - those are the frames I'm looking for!) Link to comment Share on other sites More sharing options...
katanamaru Posted June 10, 2008 Share Posted June 10, 2008 Do you mean holstering? Like pressing =+ key and putting away the weapon model? Link to comment Share on other sites More sharing options...
nizwiz Posted June 10, 2008 Author Share Posted June 10, 2008 Uhm, yeah, I guess that's what "weapon 0" does. Could you just try that console command out and see if it's the same as the one you were talking of? Link to comment Share on other sites More sharing options...
katanamaru Posted June 11, 2008 Share Posted June 11, 2008 Sure, it could take a couple of days because of homework. And if I can find the animation what should I do with it? I could write the number and name of it down for you no problem, but anything else? Link to comment Share on other sites More sharing options...
nizwiz Posted June 12, 2008 Author Share Posted June 12, 2008 Oh, don't you bother searching for it. I just asked here to see if by any chance there was someone who knew it anyway. You see, I've already looked through animation.cfg a couple of times (with modview), but haven't been able to find it. You shouldn't waste your free time on stupid requests like this. But thanks for the good intentions; I really appreciate that. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.