Jump to content

Home

WIP Plo Koon Lightsaber Hilt


alaris

Recommended Posts

Check out what I did yesterday! This hilt is one of my favorite hilts I found on http://www.thelightsaber.com/ Go to histories -- page 3. The model is based off Plo Koon's Episode I lightsaber. The site says the design is based off the action figure. His Ep 2 lightsaber looks a little too much like the other half of maul's.

 

Anywho, The model and skin are both just about finished. Let me know what you think, and if you are desirous of it.

 

saberKoon.jpg

 

Cheers!

Link to comment
Share on other sites

better than the episode 1 I did. wait until I finish resizing my episode II saber then we can release them together.

 

yeah, I checked out your hilts. A good way to check the sizing issue is to import kyle's saber and resize yours to kyle's saber's approximate proportions. Then delete kyle's saber and export away.

 

the huge hilt definately draws attention---perhaps Plo has other insecurities he is compensating for.:band:

Link to comment
Share on other sites

Great saber.....unfortunately it's not only Plo Koon's, it's Anakin's. Almost Vader's.

 

Thanks for the replies. I agree with bucmann55 that the saber is quite similar to Anakin's; yet, there are subtle differences. Check out Plo Koon's saber here:

 

http://www.thelightsaber.com/history3.htm

 

And check out Anakin's here:

 

http://www.thelightsaber.com/history1.htm

 

Because they are so similar, I might make an Anakin hilt as well. Also, I send the Plo Koon saber to jediknightii tonight or tomorrow night.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...